V0913, 9.13
independently when changing the X-axis corrections in production mode..
copy => copy CX1 to CX2 when changing CX1 (default).
delta => keep delta between CX1 and CX2 when changing CX1.
independent => change CX1 and CX2 independently.
Auto computations edit
In the Program mode you can change the value of the programmed parameters. This
can also influence the value of other parameters. With this parameter set on you can
choose to have the other values automatically recomputed.
There are three cases in which automatic computation can be used:
1. In case you change the value of the parameters 'material type' or 'material thickness'
then the following parameters are automatically recomputed and changed by the
control:
• Force
• Decompression distance
• Crowning device setting
2. In case you change the value of the parameter 'length' then the following parameters
are automatically recomputed and changed by the control:
• Force
• Decompression distance
• Crowning device setting
• Z-axis position
3. In case you change the parameter 'punch' or 'die' and the height of the new punch or
new die is different AND ONLY in case the 'bend method' is 'bottoming' or 'hemming'
then the following parameter is automatically recomputed and changed by the control:
• Y-axis position ('bend position')
(When the 'bend method' is 'air bend' (normal situation) the Y-axis position is calculated
in the automatic mode!)
If the Automatic computations edit is switched off (default situation) then these
parameters stay the same. However, when you enter these parameters by tapping them
the recomputed value is displayed. When you press 'enter' the recomputed value
replaces the old value after all. So, you can choose to change the values.
X1X2 difference programming
Parameter to select in between angle programming or offset programming for the X-
axes backgauge. Only available when this option is installed.
angular format =>X-axes angle can be programmed
projection method=>X-axes offset will result in an calculated angle
When you have two independent X-axes (X1 and X2) and the option OP-W-X@ has
been installed, you can program the values for X1, X2 in an angular relation. This means
that you program X1 and an angle value (angular method) or in a projection measure.
Please ask the option description from your supplier when this option has been installed.
Y1Y2 independent
Parameter to program the two Y-axes independently.
off => single Y-axis programming (default)
on => program Y1 and Y2 separately
To Next Page
Loading...
