V0913, 10.35
Machine frame
The side frames of the machine are part of the total machine design and important for
the bendsequence of a product in relation to possible width. Some machines have side
frames outside the bending zone and are not of influence for the collision detection. In
that case the frames do not need to be shown in the bend simulation process. With this
kind of machines the frame design can be disabled. By default this parameter is set to
Enabled.
Frame type
The default side frame type is a C-frame. An alternative O-frame can be chosen if
mounted. The O-frame is symmetrical and positioned at each side of the table.
Frame height
Total height of machine frame.
Frame width
The width (or depth) of the machine frame.
Frame thickness
The thickness of the side frame.
Throat height
The height of the workspace (the ’throat’) in the machine.
Throat width
The width (or depth) of the workspace.
Throat position
The position of the workspace in the machine.
Throat radius
The radius of the workspace corner.
To Next Page
Loading...
