1) Button position 1 to go to page with list of alarms. If an alarm is active the colour of the
triangle will be yellow
2) Button to switch ON/OFF product counter. When the button is green =ON,
when it is grey = OFF.
3) Button position 3 to go back to the previous page.
4) Button to close the page product counter.
5) Actual number of bags produced.
6) Number of bags imposed before the machine stops.
To program the number of bags to be produced proceed as follows:
Press the button position 6.
A numerical table will appear, digit desired number of bags you would like to
produce.
Press Enter to confirm.
7) The button position 7 is to reset the number of bags imposed, once this is done the
machine will start counting again from 0.
8) Button ON / OFF of the product counter to stop the machine.