Pag 78 / 154
Manuale Lyra 600 sx elettr eng
8.2 Jaw teeth adjustments
Fig. 8.1.1 Schematic to illustrate the position of the knife and anvil
Fig. 8.1.2 Enlarged drawing to show how the teeth are to be positioned in order to
achieve an efficient seal
ATTENTION To carry out this operation, operators must wear protective
gloves to protect their hands from the heat of the sealing parts since these have
to reach the set temperature before adjustments can be made. These operations
must be carried out by specialized and trained
personnel in
charge of
maintenance operations. It is recommended to contact the local distributor or
manufacturer, before carrying out these adjustments. The fin wheel pressure is
adjusted by specialised technical personnel at the manufacturer, and it should
therefore not be necessary to carry out any further adjustments.
To Next Page
Loading...