128 | Aruba Configuration Reference AirWave Wireless Management Suite | Configuration Guide
Encryption opensyst
em
Select any encryption type to be supported in this SSID profile. The supported
encryption types are as follows:
z xSec—Encrypts an original Layer-2 data frame inside a Layer-2 xSec frame, the
contents of which are defined by the protocol. xSec relies on 256-bit Advanced
Encryption Standard (AES) encryption.
z opensystem—No information sent to the client in plain text
z static-wep—Static Wired Equivalent Privacy
z dynamic-wep—Dynamic WEP with a key management service
z wpa-tkip—Wi-Fi Protected Access with Temporal Key Integrity Protocol
z wpa-aes—Wi-Fi-Protected-Access-Advanced Encryption Standard
z wpa-psk-tkip—Wi-Fi-Protected-Access-Preshared Key-Temporal Key Integrity
Protocol
z wpa-psk-aes—Wi-Fi Protected Access-Preshared Key-Advanced Encryption
Standard
z wpa2-aes—Wi-Fi-Protected Access that adds AES and CCMP
z wpa2-psk-aes—Wi-Fi Protected Access that adds Preshared Key and Advanced
Encryption Standard
z wpa2-psk-tkip—Wi-Fi Protected Access that adds Preshared Key and Temporal
Key Integrity Protocol
z wpa2-tkip—Wi-Fi Protected Access that adds Temporary Key Integrity Protocol
WEP Transmit
Key Index
1 Drop-down menu allows you to specify the key index for Wired Equivalent Privacy.
WEP Key 1 N/A Enter WEP Key 1, and confirm the key in the Confirm field.
WEP Key 2 N/A Enter WEP Key 2, and confirm the key in the Confirm field.
WEP Key 3 N/A Enter WEP Key 3, and confirm the key in the Confirm field.
WEP Key 4 N/A Enter WEP Key 4, and confirm the key in the Confirm field.
WPA Hexkey N/A Enter the hex key to be used with Wi-Fi Protected Access.
WPA
Passphrase
N/A Enter a difficult-to-guess passphrase between eight and 63 characters.
Other Settings
DTIM Interval
(1-255 beacon
periods)
1 Enter the Delivery Traffic Indication Message that informs wireless clients about the
presence of buffered, multicast, or broadcast data on the AP. The DTIM interval
specifies the beacon frequency that synchronizes the AP to the network. This setting
supports 1 to 255 milliseconds.
Station Ageout
Time
1000 Enter the amount of time, in minutes, that a client is unseen by any probes before it is
deleted from the database. Enter 0 to disable ageout.
802.11g
Transmit
Rates
All
selected
Specify the total transmit rates for the 802.11g radio. The AP attempts to use the
highest transmission rate to establish a mesh link. If a rate is unavailable, the AP goes
through the list and uses the next highest rate. All transmission rates are selected and
used. If you do not select 802.11a or 802.11g transmit rates, all rates are selected by
default when you click Apply.
802.11g Basic
Rates
1 and 2
selected
Specify the basic rates for the 802.11g radio.
802.11a
Transmit
Rates
All
selected
Specify the transmit rates for the 802.11a radio. The AP attempts to use the highest
transmission rate to establish a mesh link. If a rate is unavailable, the AP goes through
the list and uses the next highest rate. All transmission rates are selected and used by
default. If you do not select 802.11a or 802.11g transmit rates, all rates are selected
by default when you click Apply.
Table 48 Aruba Configuration > Profiles > EDCA AP Profile Settings (Continued)
Field Default Description
To Next Page
Loading...
