Dell PowerConnect W-Airwave - Page 58

58 | Aruba Configuration Reference AirWave Wireless Management Suite | Configuration Guide
Wired AP Profile default Controls whether 802.11 frames are tunneled to the controller using
Generic Routing Encapsulation (GRE) tunnels, bridged into the local
Ethernet LAN (for remote APs), or a configured for combination of the two
(split-mode). This profile also configures the switching mode
characteristics for the port, and sets the port as either trusted or untrusted.
Click the pencil icon next to this field to display the Profiles > AP > Wired
page of Aruba Configuration, and adjust these settings as desired.
Click Save on this page to return to the Add AP Group page.
For additional information, refer to “Profiles > AP > AP Wired” on page88.
Ethernet Interface 0
Link Profile
default Sets the duplex mode and speed of AP’s Ethernet link for ethernet
interface 0. The configurable speed is dependent on the port type, and you
can define a separate Ethernet Interface profile for each Ethernet link.
Click the pencil icon next to this field to display the Profiles > AP >
Ethernet Link details page of Aruba Configuration, and adjust these
settings as desired. Click Save on this page to return to the Add AP Group
page.
For additional information, refer to “Profiles > AP > AP Ethernet Link” on
page90.
Ethernet Interface 1
Link Profile
default Sets the duplex mode and speed of AP’s Ethernet link for ethernet
interface 1. The configurable speed is dependent on the port type, and you
can define a separate Ethernet Interface profile for each Ethernet link.
Click the pencil icon next to this field to display the Profiles > AP >
Ethernet Link details page of Aruba Configuration, and adjust these
settings as desired. Click Save on this page to return to the Add AP Group
page.
For additional information, refer to “Profiles > AP > AP Ethernet Link” on
page90.
AP System Profile default Defines administrative options for the controller, including the IP addresses
of the local, backup, and master controllers, Real-time Locating Systems
(RTLS) server values and the number of consecutive missed heartbeats on
a GRE tunnel before an AP reboots traps.
This field is a drop-down menu with the following options:
z Non-integer RTLS Server Station Message Frequency
z Too-high RTLS Server Port
z Too-low AeroScout RTLS Server Port
z Too-low RTLS Server Port
Click the pencil icon next to this field to display the Profiles > AP >
System details page of Aruba Configuration, and adjust these settings as
desired. Click Save on this page to return to the Add AP Group page.
For additional information, refer to “Profiles > AP > System” on page83.
Regulatory Domain
Profile
default Defines an AP’s country code and valid channels for both legacy and high-
throughput 802.11a and 802.11b/g radios.
Click the pencil icon next to this field to display the Profiles > AP >
Regulatory Domain page of Aruba Configuration, and adjust these
settings as desired. Click Save on this page to return to the Add AP Group
page.
For additional information, refer to “Profiles > AP > Regulatory Domain” on
page87.
Table 6 Aruba Configuration > AP Overrides Add or Edit Page Fields
Field Default Description