Develop ineo 3320 - Appletalk Menu

User's Guide
- 127 -
AppleTalk menu
Note: This menu is available only in printer models connected to a wired network or when an optional
network card is installed.
To access the menu, navigate to any of the following:
• Network/Ports >Standard Network >Standard Network Setup >AppleTalk
• Network/Ports >Network Setup [x] >AppleTalk
Use
To
Activate
Yes
No
Enable or disable AppleTalk support.
Note: Yes is the factory default setting.
View Name
Show the assigned AppleTalk name.
Note: The name can be changed only from the Embedded Web Server.
View Address
Show the assigned AppleTalk address.
Note: The address can be changed only from the Embedded Web Server.
Set Zone
[list of zones available on the
network]
Provide a list of AppleTalk zones available on the network.
Note: The factory default setting is the default zone for the network. If no
default zone exists, then the zone marked with an asterisk (*) is the default
setting.