User's Guide
- 38 -
4—Loading paper and specialty media
The selection and handling of paper and specialty media can affect how reliably documents print. For
more information, see
Avoiding jams and Storing paper.
Setting the paper size and type
1. From the printer control panel, navigate to:
>Settings > >Paper Menu > >Paper Size/Type >
2. Press the up or down arrow button to select the tray or feeder, and then press
.
3. Press the up or down arrow button to select the paper size, and then press
.
4. Press the up or down arrow button to select the paper type, and then press
to change the
settings.
Configuring Universal paper settings
The Universal paper size is a user-defined setting that lets you print on paper sizes that are not preset in
the printer menus.
Notes:
• The smallest supported Universal paper size is 76.2 x 127 mm (3 x 5 inches), and is supported only
from the multipurpose feeder.
• The largest supported Universal paper size is 215.9 x 355.6 mm (8.5 x 14 inches), and is supported
from all paper sources.
1. From the printer control panel, navigate to:
>Settings > >Paper Menu > >Universal Setup > >Units of Measure > >
select a unit of measure >
2. Select Portrait Width or Portrait Height, and then press
.
3. Press the left or right arrow button to change the setting, and then press
.
Loading trays
CAUTION—POTENTIAL INJURY: To reduce the risk of equipment instability, load each tray
separately. Keep all trays closed until needed.
To Next Page
Loading...
