User's Guide
- 66 -
Copying using the ADF
1. Load an original document faceup, short edge first into the ADF tray.
Notes:
- Do not load postcards, photos, small items, transparencies, photo paper, or thin media (such as
magazine clippings) into the ADF tray. Place these items on the scanner glass.
- The ADF indicator light comes on when the paper is loaded properly.
2. Adjust the paper guides.
3. From the printer control panel, use the keypad to enter the number of copies, and then press
.
Copying using the scanner glass
1. Place an original document facedown on the scanner glass in the upper left corner.
2. From the printer control panel, use the keypad to enter the number of copies, and then press
.
Note: If you want to scan another document, then place the next document on the scanner glass,
press the left or right arrow button to scroll to Scan the Next Page, and then press
.
3. Press the left or right arrow button to scroll to Finish the Job, and then press
.
Copying photos
1. Place a photo facedown on the scanner glass in the upper left corner.
2. From the printer control panel, navigate to:
>Copy > >Content Type >Photo
3. From the Content Source menu, choose a setting that best describes the original photo your are
copying, and then press
.
Note: If you want to copy another photo, then place it on the scanner glass, press the left or right
arrow button to scroll to Scan the Next Page, and then press
.
4. Press the left or right arrow button to scroll to Finish the Job, and then press
.
To Next Page
Loading...
