Develop ineo 3320 - Tray Linking Does Not Work

User's Guide
- 239 -
Action
Yes
No
Step 1
1. Make sure the size of the paper loaded in the tray matches the fuser
type.
Note: Use a 110-volt fuser for printing on letter-size paper and a 220-
volt fuser for printing on A4-size paper.
2. Resend the print job.
Does the print speed increase?
The problem is
solved.
Go to step 2.
Step 2
1. Replace the fuser. For more information on installing the fuser, see the
instruction sheet that came with the part.
2. Resend the print job.
Does the print speed increase?
The problem is
solved.
Contact technical
support.
Tray linking does not work
Notes:
• The trays can detect paper length.
• The multipurpose feeder does not automatically detect the paper size. You must set the size from the
Paper Size/Type menu.
Action
Yes
No
Step 1
1. Open the trays, and then check if they contain paper of the same size
and type.
- Check if the paper guides are in the correct positions for the size of
the paper loaded in each tray.
- Check if the paper size indicators on the paper guides are aligned
with the paper size indicators on the tray.
2. Resend the print job.
Do the trays link correctly?
The problem is
solved.
Go to step 2.