Develop ineo 3320 - Customizing Copy Settings

User's Guide
- 68 -
3. From the printer control panel, navigate to:
>Copy > >Copy from > select the size of the original document
4. Navigate to:
Copy to >
> select the tray containing the letterhead > > select the number of copies or
enter a number on the keypad >
5. If there are no trays that contain letterhead, then do the following:
a. Navigate to:
Copy to > >Manual Feeder > > select the size of the letterhead >Letterhead
b. Place the letterhead faceup, top edge first into the multipurpose feeder, and then press
.
Note: If you want to copy another document, then place it on the scanner glass, press the left or right
arrow button to scroll to Scan the Next Page, and then press
.
6. Press the left or right arrow button to scroll to Finish the Job, and then press
.
Customizing copy settings
Copying to a different size
1. Load an original document faceup, short edge first into the ADF tray or facedown on the scanner
glass.
Notes:
- Do not load postcards, photos, small items, transparencies, photo paper, or thin media (such as
magazine clippings) into the ADF tray. Place these items on the scanner glass.
- The ADF indicator light comes on when the paper is loaded properly.
2. If you are loading a document into the ADF tray, then adjust the paper guides.
3. From the printer control panel, navigate to:
>Copy > >Copy from > select the size of the original document
4. Navigate to:
Copy to >
> select a new size for the copy > select the number of copies or enter a number on
the keypad >
Note: If you want to copy another document, then place it on the scanner glass, press the left or right
arrow button to scroll to Scan the Next Page, and then press
.
5. Press the left or right arrow button to scroll to Finish the Job, and then press
.