Develop ineo 3320 - Page 132

User's Guide
- 132 -
Use
To
Eco-Mode
Off
Energy
Energy/Paper
Paper
Minimize the use of energy, paper, or specialty media.
Notes:
• Off is the factory default setting. This resets the printer to
its factory default settings.
• Energy minimizes the power used by the printer.
Performance may be affected, but print quality is not.
• Energy/Paper minimizes the use of power and of paper
and specialty media.
• Paper minimizes the amount of paper and specialty media
needed for a print job. Performance may be affected, but
print quality is not.
ADF Loaded Beep
Enabled
Disabled
Specify whether or not the ADF sounds a beep when paper is
loaded.
Note: Enabled is the factory default setting.
Run Initial setup
Yes
No
Run the setup wizard.
Notes:
• Yes is the factory default setting.
• After completing the setup wizard by selecting Done at the
country or region selection screen, the default becomes
No.
Paper Sizes
US
Metric
Specify the unit of measurement for paper sizes.
Notes:
• U.S. is the factory default setting.
• The initial setting is determined by your country or region
selection in the initial setup wizard.
Scan to PC Port Range
[port range]
Specify a valid port range for printers behind a port blocking
firewall. The valid ports are specified by two sets of numbers
separated by a semicolon.
Note: 9751:12000 is the factory default setting.