Develop ineo 3320 - Page 253

User's Guide
- 253 -
Action
Yes
No
Step 5
1. Load paper from a fresh
package.
Note: Paper absorbs moisture
due to high humidity. Store
paper in its original wrapper until
you use it.
2. Resend the print job.
Is the print still too light?
Go to step 6.
The problem is solved.
Step 6
1. Redistribute the toner in the
imaging unit.
a. Remove the toner cartridge,
and then the imaging unit.
b. Firmly shake the imaging
unit.
Warning—Potential
Damage: Do not expose
the imaging unit to direct
light for more than 10
minutes. Extended
exposure to light may cause
print quality problems.
c. Install the imaging unit, and
then the cartridge.
2. Resend the print job.
Is the print still too light?
Go to step 7.
The problem is solved.
Step 7
Replace the imaging unit, and then
resend the print job.
Is the print still too light?
Contact technical support.
The problem is solved.