Interfaces Wide Area Networks (WANs)
Digi Connect IT® 4 User Guide
117
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > Interfaces > Modem.
4. For Carrier selection mode, select one of the following:
n Automatic—The device automatically selects the carrier based on your SIM and cellular
network status.
n Manual—The device will only connect to the carrier identified in the Network PLMN ID.
If the carrier is not available, no cellular connection will be established.
n Manual/Automatic—The device will attempt to connect to the carrier identified in the
Network PLMN ID. If the carrier is not available, the device will fall back to using
automatic carrier selection.
5. If Manual or Manual/Automatic are selected for Carrier section mode, enter the Network
PLMN ID.
Note You can use the modem scan command at the Admin CLI to scan for available carriers
and determine their PLMN ID. See Scan for available cellular carriers for details.
6. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the
Connect IT 4 local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
To Next Page
Loading...
Need help?
General
