Digi Connect IT 4 User Manual

Interfaces Wide Area Networks (WANs)
Digi Connect IT® 4 User Guide
129
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the
Connect IT 4 local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new WAN or edit an existing one:
n To create a new WAN named my_wan:
(config)> add network interface my_wan
(config network interface my_wan)>
n To edit an existing WAN named my_wan, change to the my_wan node in the
configuration schema:
(config)> network interface my_wan
(config network interface my_wan)>
4. Set the appropriate firewall zone:
(config network interface my_wan)> zone zone
(config network interface my_wan)>
See Firewall configuration for further information.
5. Select an Ethernet device or a bridge. See Bridging for more information about bridging.
a. Enter device ? to view available devices and the proper syntax.
(config network interface my_wan)> device ?
Current value:
(config network interface my_wan)> device
b. Set the device for the LAN:
(config network interface my_wan)> device device
(config network interface my_wan)>
6. Configure IPv4 settings:
n IPv4 support is enabled by default. To disable:
(config network interface my_wan)> ipv4 enable false
(config network interface my_wan)>

Digi Connect IT 4 Specifications

General

Brand	Digi
Model	Connect IT 4
Category	Network Router
Language	English