Digi Connect IT 4

Interfaces Wide Area Networks (WANs)
Digi Connect IT® 4 User Guide
139
n iccid
Set the unique SIMcard ICCIDthat must be in active for this WWAN to be used:
(config network interface my_wwan)> modem iccid ICCID
(config network interface my_wwan)>
n imsi
Set the International Mobile Subscriber Identity (IMSI) that must be in active for this
WWAN to be used:
(config network interface my_wwan)> modem imsi IMSI
(config network interface my_wwan)>
n plmn_id
Set the PLMN id that must be in active for this WWAN to be used:
(config network interface my_wwan)> modem plmn_id PLMN_ID
(config network interface my_wwan)>
n sim_slot
Set which SIM slot must be in active for this WWAN to be used:
(config network interface my_wwan)> modem sim_slot value
(config network interface my_wwan)>
where value is either 1 or 2.
7. Set the PIN for the SIM. Leave blank if no PIN is required.
(config network interface my_wwan)> modem pin value
(config network interface my_wwan)>
8. Set the phone number for the SIM, for SMS connections:
(config network interface my_wwan)> modem phone num
(config network interface my_wwan)>
Normally, this should be left blank. It is only necessary to complete this field if the SIM does not
have a phone number or if the phone number is incorrect.
9. Roaming is enabled by default. To disable:
(config network interface my_wwan)> modem roaming false
(config network interface my_wwan)>
10. Set the carrier selection mode:
(config network interface my_wwan)> modem operator_mode value
(config network interface my_wwan)>
where value is one of: