Digi Connect IT 4

Serial port Configure Remote Access mode
Digi Connect IT® 4 User Guide
215
n To limit access to specified IPv4 addresses and networks:
i. Click IPv4 Addresses.
ii. For Add Address, click .
iii. For Address, enter the IPv4 address or network that can access the device's
service-type. Allowed values are:
l A single IP address or host name.
l A network designation in CIDR notation, for example, 192.168.1.0/24.
l any: No limit to IPv4 addresses that can access the service-type.
iv. Click  again to list additional IP addresses or networks.
n To limit access to specified IPv6 addresses and networks:
i. Click IPv6 Addresses.
ii. For Add Address, click .
iii. For Address, enter the IPv6 address or network that can access the device's
service-type. Allowed values are:
l A single IP address or host name.
l A network designation in CIDR notation, for example, 2001:db8::/48.
l any: No limit to IPv6 addresses that can access the service-type.
iv. Click  again to list additional IP addresses or networks.
n To limit access to hosts connected through a specified interface on the Connect IT 4
device:
i. Click Interfaces.
ii. For Add Interface, click .
iii. For Interface, select the appropriate interface from the dropdown.
iv. Click  again to allow access through additional interfaces.