Digi Connect IT 4 User Manual

Virtual Private Networks (VPN) IPsec
Digi Connect IT® 4 User Guide
342
n HTTP test: Uses HTTP(s) GET requests to determine connectivity to the configured
web server.
If HTTP test is selected, complete the following:
l Web server: The URLof the web server.
n Test DNS servers configured for this interface: Tests communication with DNS
servers that are either provided by DHCP, or statically configured for this interface.
n Test the interface status: Tests the current status of the interface. The test fails if
the interface is down. Failing this test infers that all other tests fail.
If Test the interface status is selected, complete the following:
l Down time: The amount of time that the interface is down before the test can
be considered to have failed.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and
take the format number{w|d|h|m|s}.
For example, to set Down time to ten minutes, enter 10m or 600s.
l Initial connection time: The amount of time to wait for the interface to
connect for the first time before the test is considered to have failed.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and
take the format number{w|d|h|m|s}.
For example, to set Initial connection time to ten minutes, enter 10m or 600s.
n Custom test: Tests the interface with custom commands.
If Custom test is selected, complete the following:
l The Commands to run to test.
n TCP connection test: Tests that the interface can reach a destination port on the
configured host.
If TCP connection test is selected, complete the following:
l TCP connect host: The hostname or IP address of the host to create a
TCPconnection to.
l TCP connect port: The TCP port to create a TCPconnection to.
n Test another interface's status: Tests the status of another interface.
If Test another interface's status is selected, complete the following:
l Test interface: The interface to test.
l IP version: The type of IP connection, one of:
o
Any: Either the IPv4 or IPv6 connection must be up.
o
Both: Both the IPv4 or IPv6 connection must be up.
o
IPv4: The IPv4 connection must be up.
o
IPv6: The IPv6 connection must be up.
l Expected status: The status required for the test to past.
o
Up: The test will pass only if the referenced interface is up and passing its
own SureLink tests (if applicable).

Digi Connect IT 4 Specifications

General

Brand	Digi
Model	Connect IT 4
Category	Network Router
Language	English