Virtual Private Networks (VPN) IPsec
Digi Connect IT® 4 User Guide
343
o
Down: The test will pass only if the referenced interface is down or failing its
own SureLink tests (if applicable).
e. Repeat for each additional test.
12. Add recovery actions:
a. Click to expand Recovery actions.
By default, there are two preconfigured recovery actions:
n Update routing: Uses the Change default gateway action, which increases the
interface's metric by 100 to change the default gateway.
n Restart interface.
b. Click .
New recovery actions are enabled by default. To disable, click to toggle off Enable.
c. Type a Label for the recovery action.
d. For Recovery type, select Reboot device.
e. For Recovery type, select the type of recovery action. If multiple recovery actions are
configured, they are performed in the order that they are listed.
n Change default gateway: Increases the interface's metric to change the default
gateway.
If Change default gateway is selected, complete the following:
l Attempts: The number of attempts for this recovery action to perform, before
moving to the next recovery action.
l Increase metric to change active default gateway: Increase the interface's
metric by this amount. This should be set to a number large enough to change
the routing table to use another default gateway. The default is 100.
l Override wait interval before performing the next recovery action: The
time to wait before the next test is run. If set to the default value of 0s, the Test
interval is used.
n Restart interface.
If Restart interface is selected, complete the following:
l Attempts: The number of attempts for this recovery action to perform, before
moving to the next recovery action.
l Override wait interval before performing the next recovery action: The
time to wait before the next test is run. If set to the default value of 0s, the Test
interval is used.
n Reset modem: This recovery action is available for WWANinterfaces only.
If Reset modem is selected, complete the following:
l Attempts: The number of attempts for this recovery action to perform, before
moving to the next recovery action.
To Next Page
Loading...
Need help?
General
