Digi Connect IT 4

Virtual Private Networks (VPN) OpenVPN
Digi Connect IT® 4 User Guide
403
/network/interface/defaultip
/network/interface/defaultlinklocal
/network/interface/eth1
/network/interface/eth2
/network/interface/loopback
Current value:
(config vpn openvpn client openvpn_client1 surelink tests
1)> other_interface
ii. Set the interface. For example:
(config vpn openvpn client openvpn_client1 surelink tests
1)> other_interface /network/interface/wan
(config vpn openvpn client openvpn_client1 surelink tests
1)>
l Set the type of IP connection:
(config vpn openvpn client openvpn_client1 surelink tests 1)>
other_ip_version value
(config vpn openvpn client openvpn_client1 surelink tests 1)>
where value is one of:
o
any: Either the IPv4 or IPv6 connection must be up.
o
both: Both the IPv4 or IPv6 connection must be up.
o
ipv4 The IPv4 connection must be up.
o
ipv6: The IPv6 connection must be up.
l The status required for the test to past.
(config vpn openvpn client openvpn_client1 surelink tests 1)>
other_status value
(config vpn openvpn client openvpn_client1 surelink tests 1)>
where value is one of:
o
up: The test will pass only if the referenced interface is up and passing its
own SureLink tests (if applicable).
o
down: The test will pass only if the referenced interface is down or failing its
own SureLink tests (if applicable).
f. Repeat for each additional test.
6. Add recovery actions:
a. Type ... to return to the root of the configuration:
(config vpn openvpn client openvpn_client1 surelink tests 1)> ...
(config)>