Digi Connect IT 4 User Manual

Virtual Private Networks (VPN) OpenVPN
Digi Connect IT® 4 User Guide
405
where value is one of:
n update_routing_table: Increases the interface's metric to change the default
gateway.
If update_routing_table is selected, complete the following:
l Set the number of attempts for this recovery action to perform, before moving
to the next recovery action:
(config vpn openvpn client openvpn_client1 surelink actions 0)>
max_attempts int
(config vpn openvpn client openvpn_client1 surelink actions 0)>
The default is 3.
l Set the amount that the interface's metric should be increased. This should be
set to a number large enough to change the routing table to use another
default gateway.
(config vpn openvpn client openvpn_client1 surelink actions 0)>
metric_adjustment_modem int
(config vpn openvpn client openvpn_client1 surelink actions 0)>
The default is 100.
l Set the time to wait before the next test is run. If set to the default value of 0s,
the test interval is used.
(config vpn openvpn client openvpn_client1 surelink actions 0)>
override_interval int
(config vpn openvpn client openvpn_client1 surelink actions 0)>
n restart_interface.
If restart_interface is selected, complete the following:
l Set the number of attempts for this recovery action to perform, before moving
to the next recovery action:
(config vpn openvpn client openvpn_client1 surelink actions 0)>
max_attempts int
(config vpn openvpn client openvpn_client1 surelink actions 0)>
The default is 3.
l Set the time to wait before the next test is run. If set to the default value of 0s,
the test interval is used.
(config vpn openvpn client openvpn_client1 surelink actions 0)>
override_interval int
(config vpn openvpn client openvpn_client1 surelink actions 0)>
n reset_modem: This recovery action is available for WWAN interfaces only.
If reset_modem is selected, complete the following:

Digi Connect IT 4 Specifications

General

Brand	Digi
Model	Connect IT 4
Category	Network Router
Language	English