Digi Connect IT 4

Virtual Private Networks (VPN) OpenVPN
Digi Connect IT® 4 User Guide
406
l Set the number of attempts for this recovery action to perform, before moving
to the next recovery action:
(config vpn openvpn client openvpn_client1 surelink actions 0)>
max_attempts int
(config vpn openvpn client openvpn_client1 surelink actions 0)>
The default is 3.
l Set the time to wait before the next test is run. If set to the default value of 0s,
the test interval is used.
(config vpn openvpn client openvpn_client1 surelink actions 0)>
override_interval int
(config vpn openvpn client openvpn_client1 surelink actions 0)>
n switch_sim: Switches to an alternate SIM. This recovery action is available for
WWAN interfaces only.
If switch_sim is selected, complete the following:
l Set the number of attempts for this recovery action to perform, before moving
to the next recovery action:
(config vpn openvpn client openvpn_client1 surelink actions 0)>
max_attempts int
(config vpn openvpn client openvpn_client1 surelink actions 0)>
The default is 3.
l Set the time to wait before the next test is run. If set to the default value of 0s,
the test interval is used.
(config vpn openvpn client openvpn_client1 surelink actions 0)>
override_interval int
(config vpn openvpn client openvpn_client1 surelink actions 0)>
n modem_power_cycle: This recovery action is available for WWAN interfaces only.
If modem_power_cycle is selected, complete the following:
l Set the number of attempts for this recovery action to perform, before moving
to the next recovery action:
(config vpn openvpn client openvpn_client1 surelink actions 0)>
max_attempts int
(config vpn openvpn client openvpn_client1 surelink actions 0)>
The default is 3.
l Set the time to wait before the next test is run. If set to the default value of 0s,
the test interval is used.
(config vpn openvpn client openvpn_client1 surelink actions 0)>
override_interval int
(config vpn openvpn client openvpn_client1 surelink actions 0)>