Services Location information
Digi Connect IT® 4 User Guide
519
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in Use Digi Remote Manager to view and manage your
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Services > Location > Destination servers.
4. For Add destination server, click .
5. (Optional) For Label, type a description of the location destination server.
6. For Destination server, enter the hostname or IP address of the remote host to which
location messages will be sent.
7. For Destination server port, enter the UDP or TCP port on the remote host to which location
messages will be sent.
8. For Communication protocol, select either UDP or TCP.
9. For Forward interval multiplier, select the number of Location update intervals to wait
before forwarding location data to this server. See Configure the location service for more
information about setting the Location update interval.
10. For NMEA filters, select the filters that represent the types of messages that will be
forwarded. By default, all message types are forwarded.
n To remove a filter:
a. Click the down arrow () next to the appropriate message type.
b. Click Delete.
n To add a message type:
a. For Add NMEAfilter or Add TAIP filter, click .
b. Select the filter type. Allowed values are:
l GGA: Reports time, position, and fix related data.
l GLL: Reports position data: position fix, time of position fix, and status.
l GSA: Reports GPS DOP and active satellites.
l GSV: Reports the number of SVs in view, PRN, elevation, azimuth, and SNR.
l RMC: Reports position, velocity, and time.
l VTG: Reports direction and speed over ground.
To Next Page
Loading...
Need help?
General
