Digi Connect IT 4 User Manual

Services Location information
Digi Connect IT® 4 User Guide
520
11. For TAIP filters, select the filters that represent the types of messages that will be forwarded.
By default, all message types are forwarded.
n To remove a filter:
a. Click the down arrow () next to the appropriate message type.
b. Click Delete.
n To add a message type:
a. For Add NMEAfilter or Add TAIP filter, click .
b. Select the filter type. Allowed values are:
l AL: Reports altitude and vertical velocity.
l CP: Compact position: reports time, latitude, and longitude.
l ID: Reports the vehicle ID.
l LN: Long navigation: reports the latitude, longitude, and altitude, the horizontal
and vertical speed, and heading.
l PV: Position/velocity: reports the latitude, longitude, and heading.
12. For Outgoing message type, select either NMEAor TAIP for the type of message that the
device will forward to a remote host.
(Optional) If NMEA is selected:
a. Select a Talker ID.
The talker IDis a two-character prefix in the NMEAmessage that identifies the source
type. The talker ID set here will override the talker ID from all sources, and all forwarded
sentences will use the configured ID. The default setting is Default, which means that the
talker ID provided by the source will be used.
b. Determine the Behavior when fix is invalid:
n None: No messages are sent.
n Empty: Send messages with empty fields.
n Last fix: Send messages with information from the last valid fix.
13. (Optional) For Prepend text, enter text to prepend to the forwarded message. Two variables
can be included in the prepended text:
n %s: Includes the Connect IT device's serial number in the prepended text.
n %v: Includes the vehicle ID in the prepended text.
For example, to include both the device's serial number and vehicle ID in the prepend message,
you can enter the following in the Prepend field:
__|%s|__|%v|__
14. Type a four-digit alphanumeric Vehicle ID that will be included with to location messages. If no
vehicle ID is configured, this setting defaults to 0000.
15. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the
Connect IT 4 local command line as a user with full Admin access rights.

Digi Connect IT 4 Specifications

General

Brand	Digi
Model	Connect IT 4
Category	Network Router
Language	English