Digi Connect IT 4

User authentication Example user configuration
Digi Connect IT® 4 User Guide
708
1. The user is authenticated by the RADIUS server. If the RADIUS server is unavailable,
2. The user is authenticated by the TACACS+ server. If both the RADIUSand TACACS+ servers are
unavailable,
3. The user is authenticated by the Connect IT 4 device using local authentication.
This example uses a FreeRadius 3.0 server running on ubuntu, and a TACACS+ server running on
ubuntu. Server configuration may vary depending on the platforms or type of servers used in your
environment.