Digi Connect IT 4

User authentication Example user configuration
Digi Connect IT® 4 User Guide
709
Web
1. Configure a user on the RADIUSserver:
a. On the ubuntu machine hosting the FreeRadius server, open the
/etc/freeradius/3.0/users file:
$ sudo gedit /etc/freeradius/3.0/users
b. Add a RADIUSuser to the users file:
admin1 Cleartext-Password := "password1"
Unix-FTP-Group-Names := "admin"
In this example:
n The user's username is admin1.
n The user's password is password1.
n The authentication group on the Connect IT 4 device, admin, is identified in the
Unix-FTP-Group-Names parameter.
c. Save and close the users file.
2. Configure a user on the TACACS+ server:
a. On the ubuntu machine hosting the TACACS+ server, open the /etc/tacacs+/tac_plus.conf
file:
$ sudo gedit /etc/tacacs+/tac_plus.conf
b. Add a TACACS+ user to the tac_plus.conf file:
user = admin1 {
name ="Admin1 for TX64"
pap = cleartext password1
service = system {
groupname = admin
}
}
}
In this example:
n The user's username is admin1.
n The user's password is password1.
n The authentication group on the Connect IT 4 device, admin, is identified in the
groupname parameter.
c. Save and close the tac_plus.conf file.
3. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
4. Access the device configuration:
Remote Manager: