Digi Connect IT 4 User Manual

System administration Schedule system maintenance tasks
Digi Connect IT® 4 User Guide
792
n If Check if Python Out-of-Service is set, the maintenance window will only start if the
Python Out-of-Service is set. See Use Python to set the maintenance window for further
information.
7. If Central Management is disabled, click Device firmware update to instruct the system to
look for any updated device firmware during the maintenance window. If updated firmware is
found, it will then be installed. This options is only available if Central Management is disabled;
see Central management for more information.
8. If Central Management is disabled, click to enable Modem firmware update to instruct the
system to look for any updated modem firmware during the maintenance window. If updated
firmware is found, it will then be installed. Modem firmware update looks for updated firmware
both on the local device and over the network, using either a WAN or cellular connection. This
options is only available if Central Management is disabled; see Central management for more
information.
9. (Optional) Configure automated checking for device and modem firmware updates:
a. Click to expand Firmware update check.
b. Device firmware update check is enabled by default. This enables the automated
checking for device firmware updates.
c. Modem firmware update check is enabled by default. This enables the automated
checking for modem firmware updates.
d. For Frequency, select how often automated checking for device and modem firmware
should take place. Allowed values are Daily, Weekly, and Monthly. The default is Daily.
10. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the
Connect IT 4 local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Configure a system maintenance trigger:
a. Add a trigger:
(config)> add system schedule maintenance trigger end
(config)>
b. Set the type of trigger:
(config add system schedule maintenance trigger)> type value
(config)>
where value is one of:

Digi Connect IT 4 Specifications

General

Brand	Digi
Model	Connect IT 4
Category	Network Router
Language	English