Digi Connect IT® 4 User Guide
8
Configure Remote Power Management
Configure communication between the Connect IT, power controller, and a device 40
Create an access control to specify which users can access which outlets 40
Manage power to the power controller outlets 40
Configure the Connect IT to connect to a power controller using a serial port 41
Configure a serial port for Power Management 41
Connect a power controller to the Connect IT serial port 42
Configure the power controller and the outlets for use with a serial port on the Connect IT 42
Connect a 3rd-party device to the Connect IT serial port and the power controller 43
Configure the Connect IT to connect to a power controller using the network 44
Configure communication with a power controller using the network 44
Connect the Connect IT to your network 45
Connect a 3rd-party device to a serial port on the Connect IT and then to the power
controller 45
Create an access control group for power management and assign to users 46
Manage the power to the power controller outlets from the Connect IT 47
Control the outlet power from a terminal (all users) 47
View power controller status and manage power (Administrators) 47
Control the outlet power from the Serial Status page 48
Configure Connect IT features
Configure automatic detection 49
Configure automatic detection from the web UI 49
Configure automatic detection from the script 50
Configure data pattern matching 51
Send Email notification and/or an SNMP trap when an event occurs 52
Configure email event notification 52
Configure an SNMPtrap 53
Interfaces
Wide Area Networks (WANs) 55
Wide Area Networks (WANs) and Wireless Wide Area Networks (WWANs) 56
Configure WAN/WWAN priority and default route metrics 56
WAN/WWAN failover 59
Configure SureLink active recovery to detect WAN/WWAN failures 60
Configure the device to reboot when a failure is detected 77
Disable SureLink 90
Example: Use a ping test for WAN failover from Ethernet to cellular 99
Using Ethernet devices in a WAN 101
Using cellular modems in a Wireless WAN (WWAN) 102
Configure a Wide Area Network (WAN) 125
Configure a Wireless Wide Area Network (WWAN) 133
Show WAN and WWAN status and statistics 143
Delete a WAN or WWAN 145
Default outbound WAN/WWAN ports 146
Local Area Networks (LANs) 147
About Local Area Networks (LANs) 148
Configure a Local Area Network (LAN) 148
Configure the WAN port as a LAN or in a bridge 155
Change the default LAN subnet 163
Show LAN status and statistics 165
To Next Page
Loading...
Need help?
General
