Digi Connect IT 4

Command line interface Configuration mode
Digi Connect IT® 4 User Guide
935
portal
enable false
no portals
serial
enable true
ports
0 port1
shell
enable false
(config auth user user1)>
6. Add the user to the admin group:
(config auth user user1)> add group end admin
(config auth user user1)>
7. Save the configuration and apply the change:
(config auth user user1)> save
Configuration saved.
>
8. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.