Image menu
• Brightness, Contrast, Gamma, Hue and Saturation
Set the slider or select from the drop-down list as required, to improve the quality of the image.
• Black Level Offset
Set this to 0 IRE or 7.5 IRE as required.
• Use V Position and H Position to adjust the position manually.
Video Filters
Set the sliders or select from the drop-down list as required, to improve the quality of the image:
• Sharpness - a peaking lter to increase high frequency/luminance information.
• Detail - a lter which removes low frequency image components.
• Luma Sharpness - a lter which enhances luminance sharpness.
• Chroma Sharpness - a lter which enhances the color sharpness of the chrominance signal by
increasing the steepness of color edges.
• Recursive NR - a noise reduction lter which reduces spatial & temporal noise (only applicable to
standard denition video signals).
• Mosquito NR - a noise reduction lter which reduces block artifacts (only applicable to standard
denition video signals).
• Cross Color Suppression - a lter which reduces luminance to chrominance crosstalk on
Composite Video signals. The crosstalk appears as a rainbow pattern in regions of ne detail.
VGA Setup
Use Auto Setup to allow the projector to detect the appropriate settings automatically.
If you require manual adjustment:
• Set the Phase slider to correct for shimmering or poor quality denition on, for example, ne text.
• Set the Total H Samples slider to match the resolution of the incoming video signal.
Notes
Main Menu
Image
Settings can be accessed from
the remote control as well. If your
remote is 105-023 Rev A, you
can press BRI, CON or SAT. On
105-023 Rev B, press BRI, CON or
GAMMA.
Hue applies only to NTSC signals.
When a new input mode is detected
(e.g. NTSC, HDTV 1080p, SVGA
etc.), all the input settings are saved
so that they can be recalled next
time that input mode is displayed.
Main Menu
Image
Video Filters
Main Menu
Image
VGA Setup
VGA Setup is not available unless
a VGA signal is present.
To Next Page
Loading...
