Digital Projection Titan 930 User Manual

Digital Projection Titan Quad / 930 / 800 Series USING THE PROJECTOR Operating Guide
85
Rev H October 2013
Network
This menu allows setup of two networks, Control (via the RS232 port) and LAN (via the LAN port).
Control
• Set DHCP to On if the IP Address is to be assigned by a DHCP server, or Off if it is to be set here.
• If DHCP is set to On, it will not be possible to edit either IP Address or Subnet.
• If DHCP is set to Off:
1. Edit IP Address and Subnet as required.
2. Power cycle the projector in order for the new settings to take effect.
The MAC Address of the projector is shown at the bottom of the screen.
LAN
• Set DHCP to On if the IP Address is to be assigned by a DHCP server, or Off if it is to be set here.
• If DHCP is set to On, it will not be possible to edit either IP Address or Subnet.
• If DHCP is set to Off:
1. Edit IP Address and Subnet as required.
2. Select Apply Settings and press OK.
The elds at the bottom of the menu show the current settings.
Notes
Main Menu
Setup
Network
Any new settings will not be effective
until the projector has been power
cycled.
Main Menu
Setup
Network
Control
Main Menu
Setup
Network
LAN

Digital Projection Titan 930 Specifications

General

Brand	Digital Projection
Model	Titan 930
Category	Projector
Language	English