3D menu
• Set 3D Enable to On or Off as required.
• Use the Frame Rate Multiplier to reduce icker when the incoming 3D video signal has a low
frame rate.
For example, a 48Hz frame rate could be tripled to 144Hz.
• 3D Type should be set to Auto, except when the projector has problems selecting between
Sequential, Frame Packing, Top and Bottom and Side by Side (Half).
• Set the Dark Time to reduce the ghosting that can be caused by the images overlapping whilst
the glasses are switching.
• Set the Sync Offset to compensate for signal processing delays in the projector.
• Set the Output Sync Polarity to suit the glasses, or if the left and right images appear to be
swapped.
• Set Source Dominance to Left or Right to suit the incoming 3D video signal.
L
R
Frame Packing
L
R
Top-and-Bottom
L R
Side-by-Side (Half)
L R L R
Sequential
Notes
Main Menu
3D
When using frame rate
multiplication, the nal output frame
rate must not exceed 144Hz.
Set Dark Time to the value
appropriate to the glasses or
ZScreen.
Adjust Sync Offset to eliminate
ghosting and achieve a smooth
grayscale.
For additional information on 3D
settings, see Some 3D settings
explained further in this section.
The information on this page does
not apply to 2D projectors.
To Next Page
Loading...
