Distech ECYPSE - Using the Controllers IP Address in the Web Browser

First Time Connection to an ECLYPSE Controller
ECLYPSE User Guide 59
2. In the Web browser’s address bar, type eclipse-cd4ad1.local and click go.
3. Login to the controller. Then set the controller’s configuration parameters in the
controller’s configuration Web interface. See Connecting to the Controller’s
Configuration Web Interface on page 60.
The Hostname can be changed in the System Settings on page 91.
Using the Controller’s IP Address in the Web Browser
Connect to a controller through its IP address as follows:
 For a Wi-Fi Network Connection:
1. Open your Web browser.
2. In the Web browser’s address bar, type 192.168.0.1 (the controller’s factory-default
wireless hotspot IP address) and click go.
3. Login to the controller. Then set the controller’s configuration parameters in the
controller’s configuration Web interface. See Connecting to the Controller’s
Configuration Web Interface on page 60.
 For an Ethernet Network Connection: You must know the controller’s current IP
address (from the DHCP server for example).
1. Open your Web browser.
2. In the Web browser’s address bar, enter the controller’s IP address and click go.
3. Login to the controller. Then set the controller’s configuration parameters in the
controller’s configuration Web interface. See Connecting to the Controller’s
Configuration Web Interface on page 60.