ECLYPSE Controller IP Network Protocols and Port Numbers
28 ECLYPSE User Guide
ECLYPSE IP Network Port Numbers and Protocols
ECLYPSE uses the following IP Network Protocols to communicate over IPv4 networks. The
corresponding default in-bound port number is also shown.
Default Port
Number
(Protocol)
Where can this
port number be
changed?
Outgoing Email server port number.
This parameter is normally provided by your
ISP or network administrator.
See the EC-
gfxProgram User
Guide, Resources
Configuration.
Domain Name Server URL lookup.
The router’s DHCP service that allows a
device to auto-configure a devices’ IP
settings.
EC-gfxProgram Debugging Values
(REST service): After the control logic or
code has been sent to the controller, a live
debugger allows programmers to execute
code, view input/output values, and
troubleshoot errors in real-time.
ENVYSION: The ENVYSION server
presents system status, trending
visualization, real-time equipment
visualization, schedule configuration, alarm
monitoring, and dashboard functions to a
Web browser operator interface.
Web Configuration Interface: This is the
network configuration interface for wired
and wireless IP network interfaces.
See System
Settings on page
91. If this is used
with EC-Net
AX
,
this parameter
can be changed
in the
RestService and
WebService.
Secure EC-gfxProgram Debugging
Values (REST service): After the control
logic or code has been sent to the
controller, a live debugger allows
programmers to execute code, view
input/output values, and troubleshoot errors
in real-time.
Secure ENVYSION: The ENVYSION
server presents system status, trending
visualization, real-time equipment
visualization, schedule configuration, alarm
monitoring, and dashboard functions to a
Web browser operator interface.
Secure Web Configuration Interface: This
is the network configuration interface for
wired and wireless IP network interfaces.
To Next Page
Loading...