Distech ECYPSE - Wireless Configuration

ECLYPSE Web Interface
ECLYPSE User Guide 73
Option
DHCP Client: Enabled
DHCP Client: Disabled
Gateway
This is the gateway IP
Address provided by the
network’s DHCP server.
The IP address of the default gateway to other
networks. This is usually the IP address of the
connected network router. See Default
Gateway on page 21.
Primary
DNS
Secondary
DNS
This is the primary and
secondary DNS IP Address
provided by the network’s
DHCP server.
The connected network’s primary and
secondary IP address of the DNS servers.
See Domain Name System (DNS) on page
22.
Wireless Configuration
 This configuration interface is for any ECLYPSE Wi-Fi Adapter connected to the
HOST connector.
A hotspot creates a subnetwork. As a result, any connected BACnet device will not
be able to discover BACnet devices on any other LAN subnetwork.
The Wireless connection parameters can be set as follows.
Item
Description
Enabled
This enables/disables the controller’s wireless features.
Active Mode
This sets the Wi-Fi network operating mode.
 When Active Mode is set to Client, this connects the
controller as a client of a Wi-Fi access point. See Setting up
a Wi-Fi Client Wireless Network on page 97 for how to
configure this mode.
 When Active Mode is set to Hotspot/AP and Hotspot
Configuration is set to Enabled, this creates a Wi-Fi
hotspot with a router. See Setting up a Wi-Fi Hotspot
Wireless Network on page 99 for how to configure this
mode.
 When Active Mode is set to Hotspot/AP and Hotspot
Configuration is set to Disabled, this creates a Wi-Fi
access point. See Setting up a Wi-Fi Access Point Wireless
Network on page 98 for how to configure this mode.
 When Active Mode is set to Mesh, this connects the
controller to a mesh network. See Setting up a Wi-Fi Mesh
Wireless Network on page 101 for how to configure this
mode. This feature is only available to Beta clients.
See also ECLYPSE Wi-Fi Adapter Connection Modes on page 44.
Mesh Gate
(available when
Active Mode is set
to Mesh only)
Set this option when this controller has direct access to another non-
mesh network segment through a wired Ethernet connection that
acts as a primary network interconnect. This increases the data rate
between mesh network nodes and other network segments. When
this option is enabled, this mesh node will broadcast to the other
mesh nodes at regular intervals that this mesh node has the shortest
path to other networks. Only one or two mesh network nodes should
have this option set as these broadcasts use wireless network
bandwidth.