ECLYPSE Web Interface
76 ECLYPSE User Guide
This sets the center frequency of the transmission. If there are other
Wi-Fi networks are nearby, configure each Wi-Fi network to use
different channel numbers to reduce interference and network drop-
outs.
The range of available channels may vary from country to
country.
This sets the wireless mode (wireless G or wireless N). Wireless N
mode is backwards compatible with wireless G and B. Wireless G
mode is backwards compatible with wireless B.
A mesh network uses the wireless N mode.
This shows the currently connected neighboring mesh network
controllers and the corresponding connection receive signal strength
and data rate.
This information is used to troubleshoot a mesh network. It is best
that a controller has at least two mesh network neighbors with a
receive signal strength stronger than -70 dBm.
Signal strength is measured in negative units where the
stronger the signal, the closer it is to zero. A weaker signal
strength will have a more negative number. For example, a
receive signal strength of -35 dBm is much stronger than a
receive signal strength of -70 dBm.
To Next Page
Loading...