54 of 152 PSS5000/TEMA/803046/05
PSS 5000 – Technical Manual
5 Installation (Menu 2)
Special case If you are using Application Software 411-41, then you may require more in-
formation when upgrading or downgrading, see [7].
Warning! If the BOOT upload (which is loaded with the BOOT Exchange Program)
is interrupted before it is complete, the CPB509 is left without a boot pro-
gram and cannot be used – it must be returned to Doms.
To upload software with
the web service menus
This procedure describes how to use the Service Menu in the web browser to
upload software to the PSS 5000.
Note: Before you start this procedure, read ‘Important information about
BOOT and LAM software’ on page 53.
1. Select 2 Installation → 2.6 Software Upload.
The
Software Upload page appears.
Note: A message warns you that you are about to change the permission to upload
software.
2. Select Yes, allow software upload, and do one of the following:
• If you are using a new web service menu, select either
Upload later (to
upload via FTP) or
Upload now (to upload via an embedded Java ap-
plet) and go to Step 3.
• If you are using the old web service menu, go to Step 3.
3. Do one of the following:
• If you selected
Upload later or Upload now in Step 2, open the Upload
Start Timeout
drop-down list and select the timer value. The upload
must be started within the time selected or an upload timeout occurs.
Possible timeout values are:
3 minutes, 30 minutes, 3 hours, 8 hours and
24 hours.
• If you are using the old web service menu, continue to the next step.
4. Click Accept.
• If you are using an old web service menu or you selected
Upload later,
then a message appears that tells you that the upload is possible until
the time shown.
Use a standard FTP procedure to upload the software file, see ‘To upload soft-
ware using FTP’ on page 56, and go to Step
7.
• If you selected
Upload now, a new page appears that tells you that you
are about to upload software.
To Next Page
Loading...
Need help?
General
