Draytek Vigor2760 - Static Route; Static Default Route

Vigor2760 Series User’s Guide
94
4
4
.
.
1
1
.
.
4
4
S
S
t
t
a
a
t
t
i
i
c
c
R
R
o
o
u
u
t
t
e
e
The static route is used to specify a gateway for certain LAN users for outgoing traffic.
4
4
.
.
1
1
.
.
4
4
.
.
1
1
S
S
t
t
a
a
t
t
i
i
c
c
D
D
e
e
f
f
a
a
u
u
l
l
t
t
R
R
o
o
u
u
t
t
e
e
This page is used to enable the function of default static route and specify the interface to
apply the default route. You can change the default whenever you want. If this function is not
enabled, the router will use other successful DSL connection as the default route.
Available parameters are listed below:
Item Description
IPv4
Enable - Check this box to enable the function of static
route.
Type – Choose Default Route or Load Balance.
Interface - Specify an interface for the default route.
If Load Balance is selected as the Type, you can specify
more than one interface for data transmission. Later, the
packet(s) will be sent via the specified WAN interfaces
based on the load balance policy.