Vigor2760 Series User’s Guide
59
The supported 3G USB Modem will be listed on DrayTek web site. Please visit
www.draytek.com for more detailed information.
4
4
.
.
1
1
.
.
1
1
.
.
5
5
S
S
e
e
v
v
e
e
r
r
a
a
l
l
C
C
o
o
n
n
n
n
e
e
c
c
t
t
i
i
o
o
n
n
P
P
r
r
o
o
t
t
o
o
c
c
o
o
l
l
s
s
U
U
s
s
e
e
d
d
f
f
o
o
r
r
t
t
h
h
e
e
R
R
o
o
u
u
t
t
e
e
r
r
PPPoE stands for Point-to-Point Protocol over Ethernet. It relies on two widely accepted
standards: PPP and Ethernet. It connects users through an Ethernet to the Internet with a
common broadband medium, such as a single DSL line, wireless device or cable modem. All
the users over the Ethernet can share a common connection. And the PPPoA stands for
Point-to-Point Protocol over ATM. PPPoA uses the PPP dial-up protocol with ATM as the
transport.
PPPoE or PPPoA is used for most of DSL modem users. All local users can share one PPPoE
or PPPoA connection for accessing the Internet. Your service provider will provide you
information about user name, password, and authentication mode.
DHCP stands for Dynamic Host Configuration Protocol. The router by factory default acts a
DHCP server for your network so it automatically dispatch related IP settings to any local user
configured as a DHCP client. It is highly recommended that you leave the router enabled as a
DHCP server if you do not have a DHCP server for your network.
DHCP allows a user to obtain an IP address automatically from a DHCP server on the Internet.
If you choose DHCP mode, the DHCP server of your ISP will assign a dynamic IP address for
your router automatically. It is not necessary for you to assign any setting,
For Static
/
/RFC1483_ROUTED/RFC1483 BRIDGE IP mode, you usually receive a fixed
public IP address or a public subnet, namely multiple public IP addresses from your DSL or
Cable ISP service providers. In most cases, a Cable service provider will offer a fixed public
IP, while a DSL service provider will offer a public subnet. If you have a public subnet, you
could assign an IP address or many IP address to the WAN interface.
4
4
.
.
1
1
.
.
1
1
.
.
6
6
W
W
A
A
N
N
S
S
t
t
a
a
t
t
u
u
s
s
This page displays current status for physical WAN connection. [WAN]Ethernet1 indicates
the network connection via Ethernet port; [DSL]PVC1 indicates the network connection via
DSL interface; [USB] 3G_BACKUP indicates the backup network connection via USB
interface.
Each item will be explained as follows:
Item Description
Dial
Click it to start the network connection via DSL or USB
interface. Before clicking it, check the interface you want.
Drop
Click it to terminate the network connection via DSL or USB
interface.
Refresh
Click it to refresh the web page.
Name
Display the profile name for DSL/USB interface.
To Next Page
Loading...
Need help?
General
