Duplo DP-440 - Acceptable Documents; Acceptable Printing Paper; Document;Printing Paper Specification

28
Acceptable Documents
■ Document glass plate
•Weight : Sheet documents, books, etc, not exceeding 10kg.
• Size : 297mm x 432mm max.
■ ADF
Acceptable Printing Paper
• Document thickness : 64g/m
2
to 128g/m
2
• Document size : 297mm x 432mm max.
100mm x 148mm max.
•Stacking capacity in document tray : 100 sheets (64g/m
2
)
IMPORTANT
The following types of document cannot be used:
• Documents with large file-binding holes, tears, or missing parts
• Documents with staples or paper clips attached
• Documents with markedly curling ends/sides, or marked folds
• Carbon-backed documents
• Sticky documents
• Highly transparent documents such as OHP film
When ADF is Installed:
•To make a new plate from a document from which a plate has already been made, remove
and then reload the document.
• Always use documents of the same size.
• If you load documents of different lengths, the printer may not operate correctly.
Acceptable Printing Paper
Paper thickness
Paper size
Paper stacking capacity
IMPORTANT
The following types of paper cannot be used.
•Paper with large file-binding holes
• Paper with staples or paper clips attached
• Paper with markedly curling ends/sides, or marked folds
• Carbon-backed paper
• Paper with smaller pieces of glued paper
Document/Printing Paper Specification
53g/m
2
to 210g/m
2
(13lb to 110lb)
Max. 297mm x 432 mm
Min. 100mm x 150 mm
Feed tray : 1500 sheets (64g/m
2
top-grade paper)
Print tray : 1500 sheets (64g/m
2
top-grade paper)