Settings via software (OP7000)
Operating Instructions 650-10 - 03.0 - 08/2016 103
Fig. 67: Length correction (LENGTH CORRECTION) (2)
4. Do the same with all further sewing steps.
5. After the last sewing step tap the EN
D button.
Th
is closes the length correction, and the operating
mode EDIT ( p. 85) opens.
6.6 Displaying the software version
To display the software version:
1. Switch on and off the machine.
Th
e following appears on the display:
• On the left, the class
•
On the right, the firmware
T
he machine performs a reference run.
Th
e controller starts in the operating mode that was active
when it was switched off - MAN or AUTO.
6.7 Operating mode SERVICE
More information on the contents of Service mode can be found
in the Service Instructions.
To Next Page
Loading...
