Service settings via software (OP3000)
Operating Instructions 650-10 - 03.0 - 08/201660
Select another program number using / or input a
program number using the keypad keys 0 – 9 and then
press the OK key.
The program number is loaded.
The display shows the following information,
the P i
n the program number field flashes:
Fig. 37: Copying the sewing program (3)
4. Load the desired changes into the new sewing program.
5. Press the ESC key
.
Th
e controller switches to Edit mode to Automatic mode.
5.6.4 Deleting the sewing program
The selected sewing program is deleted.
Proceed as follows to delete an existing sewing program:
1. Press the key.
Th
e softkey menu appears on the display:
Fig. 38: Deleting the sewing program
2. Press the key.
3. Press the ESC key.
Th
e controller switches to Edit mode to Automatic mode.
To Next Page
Loading...
