Settings via software (OP7000)
Operating Instructions 650-10 - 03.0 - 08/201672
6.3.1 Parameters that can be set
The following table lists the parameters that can be set in MAN
operating mode.
To set a parameter:
1. Tap the desired button.
Th
e user interface for setting the desired parameter is
displayed.
For some parameters the setting is more
than just a numerical
value. These parameters are described below.
Symbol/button Meaning
Setting the fullness, p. 73
Set the curve support.
Other program parameters in manual
mode MAN, p. 74
Inputting the needle thread tension
Inputting the stitch length in mm
To Next Page
Loading...
