Setup
Operating Instructions 650-10 - 03.0 - 08/2016 123
8.7 Setting the working height
The working height can be adjusted between 780 and 900 mm
(measured to the upper edge of the table plate).
WARNING
Risk of injury from moving parts!
When loosening the screws at the frame braces
the tabl
e top can sink down by its weight.
Crushing is possible.
Take care not to crush your hands when
l
oosening the screws.
CAUTION
Risk of impairment of the musculoskeletal
s
ystem from wrong adjustment!
The musculoskeletal system of the operator can
b
e damaged by noncompliance of the ergonomic
requirements.
Adjust the working height
to the body dimension
of the person who will operate the machine.
To Next Page
Loading...
