Operation
Operating Instructions 650-10 - 03.0 - 08/2016 25
4.5 Winding the hook thread
Fig. 6: Winding the hook thread
You wind the hook thread as follows:
1. Fit the bobbin (2) on the bobbin shaft.
2. Thread the hook thread as shown in the figure.
3. Wind the hook thread clockwise on to the bobbin core.
4. Swing the bobbin winder flap (1) against the bobbin (2).
5. Switch on the machine.
6. Start sewing ( p. 35).
7. The bobbin winder stops automatically when the configured
bobbin filling length has been reached
( Service Instructions).
8. Pull off the bobbin, clamp the thread under the cutter (3) and
tear it off.
NOTICE
Property damage may occur!
Moving the bobbin without performing sewing can cause
damage
to the presser foot and the bobbin case in the hook.
Activate bobbin mode if you wish to wind the hook thread
without performing
sewing.
(1) - Winder flap
(2) - Bobbin
(3) - Cutter
To Next Page
Loading...
