Setup
Operating Instructions 650-10 - 03.0 - 08/2016120
8. Tighten the setpoint device for the main pedal at (7)
(chipboard screws 4 x 20).
9. Tighten the setpoint device for the additional pedal at (5)
(chipboard screws 4 x 20).
Larger scale diagrams can be found in the appendix ( p. 161).
8.5 Attaching the tabletop and pedals to
the stand
Fig. 80: Attaching the tabletop and pedals
Attach the tabletop and the pedals to the stand as follows:
1. Using wood screws (6 x 30), attach the stand (2) to the
t
abletop (1). Drill pilot holes for the wood screws.
2. Observe the center marks for the stand.
(1) - Tabletop
(2) - Stand
(3) - Screws
(4) - Main pedal
(5) - Stand strut
(6) - Thread reel holder
To Next Page
Loading...
