Service settings via software (OP3000)
Operating Instructions 650-10 - 03.0 - 08/2016 61
5.6.5 Mirroring the sewing program
The sleeve side already programmed is mirrored over to the other
sleeve side.
Proceed as follows to mirror a sewing program:
1. Press the key.
The softkey menu appears on the display:
Fig. 39: Mirroring the sewing program
2. Press the key.
3. Press the ESC key.
Th
e controller switches to Edit mode to Automatic mode.
5.7 Displaying the software version
To display the software version:
1. Switch off and on the machine.
Th
e splash screen appears on the display:
• On the left, the control panel firmware
•
On the right, the controller software version
Fig. 40: Displaying the software version
The machine performs a reference run:
The display shows the sewing program last used,
or Manual mode.
To Next Page
Loading...
