Settings via software (OP7000)
Operating Instructions 650-10 - 03.0 - 08/2016 77
Left pane (2)
The graphical representation of the entire seam, divided into the
number of programmed sewing steps, is displayed here. A red bar
with an arrowhead indicates the direction of sewing and progress
of the sewn seam.
Middle pane (3)
The number and the name of the selected sewing program are
displayed here, together with the symbols for all the parameters
that can be set. The gray fields above the parameter symbols
show the respective current values.
Right pane (4)
Another user interface or another operating mode can be selected
here.
6.4.1 Parameters that can be set
The following table lists the parameters that can be set in AUTO
operating mode.
Symbol/button Meaning
Program selection, p. 79
Select the right or left piece to be sewn
Set the sewing material size, p. 80
Other program parameters in manula
mode AUTO, p. 83
Temporarily setting the fullness value until
the next sewing step, p. 81
To Next Page
Loading...
