Settings via software (OP7000)
Operating Instructions 650-10 - 03.0 - 08/201678
To set a parameter:
1. Tap the desired button.
Th
e user interface for setting the desired parameter is
displayed.
For some parameters the setting is more
than just a numerical
value. These more complex parameters are described in detail
below.
Applying a % correction to the fullness
values of all sewing steps, p. 82
Setting the needle thread tension.
If changed in AUTO operating mode, the
value is permanently saved in the sewing
program.
Setting the stitch length in mm.
If changed in AUTO operating mode, the
value is permanently saved in the sewing
program.
Symbol/button Meaning
To Next Page
Loading...
