Setup
Operating Instructions 650-10 - 03.0 - 08/2016 119
8.4 Pre-assembling the tabletop
Fig. 79: Pre-assembling the tabletop
To pre-assemble the tabletop:
1. Turn the tabletop over so that it
s bottom side is facing up.
2. Tighten the controller at (2) (chipboard screws 5 x 30).
3. Use screws to tighten the permanent magnets of the tilt
sensor (8) for the machine head (accessory pack) on the
underside of the tabletop.
4. Tighten the drawer and its brackets at (9)
(chipboard screws 3.5 x 17).
5. Tighten the knee lever at (3).
6. Tighten the strain relief mechanism at (4)
(chipboard screws 3.5 x 17).
7. Tighten the cable duct (40 x 40 x 250 mm long) at (6)
(chipboard screws 3.5 x 17).
(1) - Stand
(2) - Controller
(3) - Knee lever
(4) - Strain relief mechanism
(5) - Setpoint device for additional
pedal
(6) - Cable duct
(7) - Setpoint device for main pedal
(8) - Tilt sensor
(9) - Drawer
④③②
⑥⑤①⑦⑨⑧
To Next Page
Loading...
